DTC P0095 Intake Air Temperature Sensor 2 Circuit |
DTC P0097 Intake Air Temperature Sensor 2 Circuit Low |
DTC P0098 Intake Air Temperature Sensor 2 Circuit High |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0095 | Open or short in diesel turbo IAT sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0097 | Short in diesel turbo IAT sensor circuit for 0.5 seconds (sensor resistance value less than 25 Ω [sensor output voltage less than 0.05 V]) (1 trip detection logic) |
|
| P0098 | Open in diesel turbo IAT sensor circuit for 0.5 seconds (sensor resistance value more than 156 kΩ [sensor output voltage more than 4.9 V]) (1 trip detection logic) |
|
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) or more | Short circuit |

| 1.READ VALUE USING INTELLIGENT TESTER (INTAKE AIR TEMP [TURBO]) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Intake Air Temp (Turbo).
Read the value.
| Temperature Displayed | Proceed to |
| -40°C (-40°F) | A |
| 140°C (284°F) or more | B |
| OK (same as air temperature near to intake manifold) | C |
|
| ||||
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (CHECK FOR OPEN IN WIRE HARNESS) |
![]() |
Disconnect the I4 diesel turbo IAT sensor connector.
Connect terminals 1 and 2 of the diesel turbo IAT sensor wire harness side connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Intake Air Temp (Turbo).
Read the value.
|
| ||||
| NG | |
| 3.READ VALUE USING INTELLIGENT TESTER (CHECK FOR OPEN IN ECM) |
![]() |
Disconnect the I4 diesel turbo IAT sensor connector.
Connect terminals THIA and E2 of the E8 ECM connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Intake Air Temp (Turbo).
Read the value.
|
| ||||
| NG | ||
| ||
| 4.READ VALUE USING INTELLIGENT TESTER (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the I4 diesel turbo IAT sensor connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Intake Air Temp (Turbo).
Read the value.
|
| ||||
| NG | |
| 5.READ VALUE USING INTELLIGENT TESTER (CHECK FOR SHORT IN ECM) |
![]() |
Disconnect the I4 diesel turbo IAT sensor connector.
Disconnect the E8 ECM connector.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine / Data List / Intake Air Temp (Turbo).
Read the value.
|
| ||||
| NG | ||
| ||