DRIVE BELT > INSTALLATION |
| 1. INSTALL TENSIONER PULLEY |
![]() |
Install the dust seal and bolt to the tensioner pulley as shown in the illustration.
![]() |
Set the nut in place on the tensioner arm so that the flat face of the nut contacts the tensioner arm as shown in the illustration.
Tighten the bolt by hand until the flange of the bolt contacts the dust seal and the tensioner pulley is fixed in place.
Tighten the bolt.
Install a new O-ring and the dipstick guide with the bolt.
Install the oil dipstick.
| 2. INSTALL DRIVE BELT |
![]() |
Install the drive belt to the pulleys except the drive belt tensioner pulley.
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.
![]() |
After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.