DTC P0571 Stop Light Switch Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0571 | When the voltage of the STP terminal and the ST1- terminal of the ECM is below 1 V for 0.5 sec. or more. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Using the intelligent tester, read the Data List.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Stop Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT FUSE (STOP, IGN) |
Disconnect the STOP and IGN fuses from the driver side junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| STOP fuse | Always | Below 1 Ω |
| IGN fuse |
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin pushed | 10 kΩ or higher |
| Pin not pushed | Below 1 Ω | |
| 3 - 4 | Pin pushed | Below 1 Ω |
| Pin not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BATTERY - STOP LIGHT SWITCH) |
![]() |
Disconnect the S14 stop light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S14-2 - Body ground | Always | 11 to 14 V |
| S14-3 - Body ground | Ignition switch ON |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - ECM) |
![]() |
Disconnect the S14 stop light switch connector.
Disconnect the E14*1 or E6*2 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S14-1 - E14-15 (STP) | Always | Below 1 Ω |
| S14-1 - Body ground | Always | 10 kΩ or higher |
| S14-4 - E14-16 (ST1-) | Always | Below 1 Ω |
| S14-4 - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| S14-1 - E6-15 (STP) | Always | Below 1 Ω |
| S14-1 - Body ground | Always | 10 kΩ or higher |
| S14-4 - E6-14 (ST1-) | Always | Below 1 Ω |
| S14-4 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||