Home › DRIVE LINE › PROPELLER SHAFT › REAR PROPELLER SHAFT ASSEMBLY (for TSAM Made)

REAR PROPELLER SHAFT ASSEMBLY (for TSAM Made) > INSTALLATION

for Preparation Click here



1. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 2WD and Pre-Runner)


C098710E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.

  1. Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.



    C119752E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



    C118622E01
  1. Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }



2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD)


C118613E01
  1. Align the matchmarks on the propeller shaft flange and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



    C118612
  1. Install the center support bearing bracket with the 2 plates and 2 bolts. Tighten the bolts as much as possible by hand.

  1. Align the matchmarks on the propeller shaft flange and differential flange.



    C119752E01
  1. Install the propeller shaft with the 4 bolts, 4 washers and 4 nuts.

    Torque:
    88 N*m{ 897 kgf*cm , 65 ft.*lbf }



    C118622E01
  1. Unload the vehicle. The center line of the center bearing and center bearing housing (see illustration) must be adjusted to within 0 +-1 mm (0 +-0.04 in.) of each other. Measure the difference along the vehicle front/rear axis.

  1. Tighten the 2 bolts of the center support bearing bracket.

    Torque:
    36 N*m{ 367 kgf*cm , 27 ft.*lbf }