Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 2WD)

FRONT AXLE HUB (for 2WD) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FRONT AXLE HUB BEARING


F050084E01
  1. Remove the front wheel.

  1. TSAM made:
    Remove the front disc brake cylinder (Click here).

  1. TMT made:
    Remove the front disc brake cylinder (Click here).

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum backlash:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.



    F050083E01
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the deviation on the surface of the axle hub.

      Maximum deviation:
      0.05 mm (0.0020 in.)

      If the deviation is greater than the maximum, replace the bearing.