Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER (for TMT Made LHD without ABS)

BRAKE MASTER CYLINDER (for TMT Made LHD without ABS) > REMOVAL

for Preparation Click here



1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



2. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


C122089E01
  1. M/T:
    Disconnect the clutch reservoir tube labeled A from the master cylinder.

  1. Disconnect the brake fluid warning switch connector labeled B.

  1. Using SST, disconnect the 6 brake lines labeled C from the master cylinder and 4-way.

    SST
    09023-00101  



    C122091
  1. Remove the 2 nuts and bracket (with 4-way).

  1. Pull out the master cylinder from the brake booster.

  1. Remove the O-ring from the master cylinder.



3. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Remove the screw.

  1. Remove the reservoir and 2 grommets from the master cylinder.