Home › BRAKE › BRAKE › FRONT BRAKE (for TSAM Made 2WD)

FRONT BRAKE (for TSAM Made 2WD) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT DISC BRAKE PAD
  1. Remove the 2 disc brake pads.



2. REMOVE ANTI SQUEAL SHIM KIT FRONT
  1. Remove the shims from each pad.



3. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 2 plates from the brake cylinder mounting.



4. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING


C111362
  1. Remove the 2 bolts and cylinder mounting.



5. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


    C121984
  1. Remove the 2 pins (upper and lower) from the mounting.



    C121985E01
  1. Using a screwdriver, remove the slide bush from the pin (lower).

    NOTICE:
    Be careful not to damage the pin.



6. REMOVE FRONT DISC BRAKE BUSH DUST BOOT


    C121986
  1. Remove the 2 boots from the mounting.



7. REMOVE CYLINDER BOOT


C121987
  1. Using a screwdriver, pry out the set ring and boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.



8. REMOVE FRONT DISC BRAKE PISTON


C111364E01
  1. Prepare a wooden plate to hold the pistons.



    C121988
  1. Place the wooden plate between the piston and cylinder.

  1. Use compressed air to remove the piston from the cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.



9. REMOVE PISTON SEAL


C111366
  1. Using a screwdriver, pry out the seal from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and cylinder groove.



10. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.



11. REMOVE FRONT DISC


C111369E01
  1. Put matchmarks on the disc and axle hub.

  1. Remove the disc.