FRONT BRAKE (for TSAM Made 2WD) > REASSEMBLY |
| 1. INSTALL FRONT DISC |
![]() |
Align the matchmarks and install the disc.
| 2. CHECK DISC RUNOUT |
![]() |
Check the bearing play in the axial direction and check the axle hub runout .
Temporarily install the disc to the hub with the hub nuts.
Using a dial indicator, measure the disc runout 10.0 mm (0.39 in.) from the outer edge of the disc.
Remove the 2 nuts.
| 3. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG |
Install the bleeder plug to the cylinder.
Install the cap.
| 4. INSTALL PISTON SEAL |
Apply lithium soap base glycol grease to a new seal.
Install the seal to the cylinder.
| 5. INSTALL FRONT DISC BRAKE PISTON |
![]() |
Apply lithium soap base glycol grease to the piston and a new cylinder boot.
Install the boot to the piston.
Install the piston (with boot) to the cylinder.
| 6. INSTALL CYLINDER BOOT |
![]() |
Using SST and a hammer, tap in the boot to the cylinder.
Using a screwdriver, install the set ring.
| 7. INSTALL FRONT DISC BRAKE BUSH DUST BOOT |
![]() |
Apply lithium soap base glycol grease to 2 new boots.
Install the 2 boots to the mounting.
| 8. INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN |
![]() |
Apply lithium soap base glycol grease to the pins and a new bush as shown in the illustration.
Install the bush to the pin (lower).
![]() |
Install the 2 pins (upper and lower) to the mounting.
| 9. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING |
![]() |
Install the cylinder mounting with the 2 bolts.
| 10. INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE |
Install the 2 plates to the mounting.
| 11. INSTALL FRONT ANTI SQUEAL SHIM KIT |
![]() |
Install the No. 1 and No. 2 shims to each pad.
| 12. INSTALL FRONT DISC BRAKE PAD |
Install the 2 disc brake pads to the mounting.