Home › BRAKE › PARKING BRAKE › PARKING BRAKE SYSTEM

PARKING BRAKE SYSTEM > ADJUSTMENT

for Preparation Click here



1. REMOVE REAR WHEEL


2. ADJUST BRAKE SHOE CLEARANCE


3. INSTALL REAR WHEEL

Torque:
152 N*m{ 1550 kgf*cm , 112 ft.*lbf } for 2WD (steel type)
121 N*m{ 1234 kgf*cm , 89 ft.*lbf } for 2WD (aluminum type)
105 N*m{ 1070 kgf*cm , 77 ft.*lbf } for 4WD and pre-runner



4. CHECK PARKING BRAKE LEVER TRAVEL
  1. Pull the lever upward with a force of approximately 200 N (20 kgf, 45 lbf) and count the number of clicks.

    Standard:
    6 to 8 clicks (for 2WD)
    7 to 9 clicks (for 4WD and pre-runner)

    If the parking brake lever travel is not as specified adjust the parking brake lever travel.



5. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B087844E01
  1. Detach the 4 claws and remove the hole cover.



6. ADJUST PARKING BRAKE LEVER TRAVEL


C112487
  1. Loosen the lock nut.

  1. Turn the No. 1 wire adjusting nut until the lever travel is correct.

  1. Tighten the lock nut.

    Torque:
    5.2 N*m{ 53 kgf*cm , 46 in.*lbf }

    HINT:
    If further adjustment is necessary, proceed to the next step.



7. ADJUST PARKING BRAKE TURN BUCKLE


F050156E01
  1. Loosen the lock nut and turn the buckle until the lever travel is correct.

  1. Tighten the lock nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



8. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY


B087844E02
  1. Attach the 4 claws to install the hole cover.