Home › TRANSMISSION · A343E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY


G026080E33
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Shift Lever Position
    Specified Condition
    4 (B) - 5 (L)
    Shift lever in P or N
    Below 1 Ω
    4 (B) - 5 (L)
    Shift lever not in P or N
    10 kΩ or higher
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever not in R
    10 kΩ or higher
    2 (RB) - 7 (DL)
    Shift lever in D
    Below 1 Ω
    2 (RB) - 7 (DL)
    Shift lever not in D
    10 kΩ or higher
    2 (RB) - 3 (2L)
    Shift lever in 2
    Below 1 Ω
    2 (RB) - 3 (2L)
    Shift lever not in 2
    10 kΩ or higher
    2 (RB) - 8 (LL)
    Shift lever in L
    Below 1 Ω
    2 (RB) - 8 (LL)
    Shift lever not in L
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.