AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 nuts, 4 bolts and frame crossmember.
| 3. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the front exhaust pipe (Click here).
| 4. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY |
Remove the propeller with center bearing shaft assembly (Click here).
| 5. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain ATF.
Install a new gasket and the drain plug.
| 6. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() |
Remove the oil dipstick.
Remove the 2 bolts and oil filler tube.
Remove the O-ring from the oil filler tube.
| 7. DISCONNECT OIL COOLER TUBE |
![]() |
Using a union nut wrench, disconnect the tube outlet and tube inlet.
![]() |
Remove the 3 bolts and 3 clamps.
| 8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Remove the nut and disconnect the control cable.
Remove the clip and disconnect the control cable.
| 9. REMOVE TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and control cable bracket from the transmission.
| 10. REMOVE STARTER ASSEMBLY |
| 11. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Support the transmission with a transmission jack.
| 12. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
*1: Remove the 4 set bolts of the No. 1 engine mounting insulator rear.
*2: Remove the 4 nuts, 4 bolts and frame crossmember.
| 13. DISCONNECT CONNECTOR |
![]() |
Tilt the transmission downward.
Disconnect the connectors.
Disconnect the temperature sensor connector.
Disconnect the park/neutral position switch connector.
Disconnect the 3 speed sensor connectors.
Disconnect the transmission wire connector.
| 14. DISCONNECT WIRE HARNESS |
| 15. REMOVE FLYWHEEL HOUSING DUST SEAL |
| 16. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY |
![]() |
Turn the crankshaft to gain access to each bolt.
Hold the crankshaft pulley bolt with a wrench and remove the 6 torque converter clutch mounting bolts.
![]() |
Remove the 3 bolts and exhaust manifold stay.
![]() |
Remove the 7 bolts.
Separate the transmission from the engine.
| 17. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR |
![]() |
Remove the 4 bolts and engine mounting insulator.
| 18. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY |