Home › DRIVE LINE › PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made)

FRONT PROPELLER SHAFT ASSEMBLY (for TSAM Made) > REMOVAL

for Preparation Click here



1. REMOVE FRONT PROPELLER SHAFT ASSEMBLY


C098708E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Remove the 4 nuts, 4 bolts and 4 washers, and disconnect the propeller shaft.



    F052086E01
  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 4 nuts, 4 washers and front propeller shaft.