MANUAL TRANSMISSION ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
w/ M/T:
Twist the knob in the direction indicated by the arrow and remove it.
w/ 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow and remove it.
| 3. REMOVE UPPER CONSOLE PANEL ASSEMBLY |
![]() |
Detach the 12 claws and remove the console panel.
| 4. REMOVE CONSOLE BOX ASSEMBLY |
![]() |
Remove the 4 screws <F> and 2 bolts <E>.
Using a clip remover, remove the 2 clips and console box.
| 5. REMOVE SHIFT LEVER BOOT ASSEMBLY |
![]() |
w/o Console Box:
Remove the front seat, front door scuff plate, etc. and fold back the floor carpet so that the shift lever can be removed.
Remove the 4 screws, 2 clips and shift lever boot.
| 6. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY |
![]() |
Cover the shift lever cap with a cloth.
Press down on the shift lever cap and rotate it counterclockwise to remove it.
Pull out the shift lever.
| 7. DRAIN MANUAL TRANSMISSION OIL |
Remove the drain plug and gasket to drain the oil.
Install a new gasket and the drain plug.
| 8. REMOVE NO. 2 CROSSMEMBER SUB-ASSEMBLY |
![]() |
Remove the 4 bolts, 4 nuts and frame crossmember.
| 9. REMOVE REAR PROPELLER SHAFT ASSEMBLY |
Remove the rear propeller shaft (Click here).
| 10. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the front exhaust pipe (Click here).
| 11. DISCONNECT WIRE HARNESS |
Disconnect the back-up light switch connector and speedometer sensor connector.
| 12. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the release cylinder.
| 13. REMOVE STARTER ASSEMBLY |
Remove the starter (Click here).
| 14. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY |
![]() |
Support the transmission rear side with a support stand.
Remove the 4 set bolts of the rear No. 1 engine mounting insulator.
Remove the 4 bolts, 4 nuts and frame crossmember.
| 15. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR |
![]() |
Remove the 4 bolts and mounting insulator.
| 16. REMOVE STIFFENER PLATE |
![]() |
Remove the 4 bolts and stiffener plate RH.
Remove the 4 bolts and stiffener plate LH.
| 17. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY |
![]() |
Using a transmission jack, support the transmission.
Remove the support stand from the rear side.
Remove the 4 bolts and transmission.