FUEL INJECTION NOZZLE > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DISCONNECT AIR CLEANER HOSE |
Disconnect the IAT sensor connector.
Detach the clamp of the IAT sensor harness.
Loosen the 2 clamps from the air cleaner hose.
Remove the air cleaner hose.
| 3. REMOVE INTAKE PIPE ASSEMBLY |
![]() |
Remove the 2 bolts and loosen the hose clamp.
| 4. REMOVE VENTURI |
![]() |
Disconnect the throttle open switch connector.
![]() |
Disconnect the throttle control motor connector.
Remove the venturi and gasket.
| 5. REMOVE INJECTION PIPE SET |
![]() |
Using SST, loosen the 8 union nuts of the 4 injection pipes.
Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with lower pipe clamps.
| 6. REMOVE NO. 1 GLOW PLUG CONNECTOR |
Remove the nut and wire harness.
Remove the 4 screw grommets, 4 nuts and glow plug connector.
| 7. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY |
![]() |
Disconnect the fuel hose from the leakage pipe.
Remove the 4 nuts, leakage pipe and 4 ring packing washers.
| 8. REMOVE NOZZLE HOLDER AND NOZZLE SET |
![]() |
Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.