Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB (for 4WD and Pre-Runner)

FRONT AXLE HUB (for 4WD and Pre-Runner) > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK FRONT AXLE HUB BEARING


F042746E01
  1. Remove the front wheel.

  1. for TMT made 4WD:
    Remove the front disc brake cylinder (Click here).

  1. for TSAM made 4WD and Pre-Runner:
    Remove the front disc brake cylinder (Click here).

  1. Remove the front disc.

  1. Inspect the axle hub backlash.

    1. Using a dial indicator, check the backlash near the center of the axle hub.

      Maximum backlash:
      0.05 mm (0.0020 in.)

      If the backlash is greater than the maximum, replace the bearing.



    F042745E01
  1. Inspect the axle hub deviation.

    1. Using a dial indicator, check the deviation at the surface of the axle hub.

      Maximum deviation:
      0.05 mm (0.0020 in.)

      If the deviation is greater than the maximum, replace the bearing.