Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Tachometer Malfunction

for Preparation Click here


WIRING DIAGRAM


E115290E12


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
E076236E01
  1. Disconnect the C8 meter connector.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Tester Connection
    Tool Setting
    Vehicle Condition
    C8-7 - Body ground
    5 V/DIV., 10 msec./DIV.
    Engine idling

    OK:
    Refer to the illustration.

    HINT:
    As the engine speed increases, the wavelength shortens.



OK
REPLACE COMBINATION METER ASSEMBLY
NG


2.CHECK WIRE HARNESS (METER - ECM)

E118140E01

  1. Disconnect the C8 meter connector.

  1. Disconnect the E10*1, E13*2, E5*3 or E21*4 ECM connector.

HINT:
*1: 1TR-FE, 2TR-FE
*2: 1GR-FE
*3: 1KD-FTV, 2KD-FTV
*4: 5L-E

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    1TR-FE, 2TR-FE 
    Tester Connection
    Specified Condition
    C8-7 - E10-1 (TACH)
    Below 1 Ω

    1GR-FE:
    Tester Connection
    Specified Condition
    C8-7 - E13-1 (TACH)
    Below 1 Ω

    1KD-FTV, 2KD-FTV:
    Tester Connection
    Specified Condition
    C8-7 - E5-4 (TACH)
    Below 1 Ω

    5L-E:
    Tester Connection
    Specified Condition
    C8-7 - E21-7 (TACH)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

GO TO SFI SYSTEM (1TR-FE, 2TR-FE, 1GR-FE), ECD SYSTEM (1KD-FTV, 2KD-FTV, 5L-E)