Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


WIRING DIAGRAM


E111791E10


INSPECTION PROCEDURE

1.INSPECT FRONT SEAT INNER BELT ASSEMBLY (BUCKLE SWITCH)
E110284E01
  1. Disconnect the F12 belt connector.

  1. Measure the resistance of the buckle switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened (ON)
    Below 1 Ω
    Seat belt is fastened (OFF)
    1 MΩ or higher



NG
REPLACE FRONT SEAT INNER BELT ASSEMBLY
OK


2.CHECK WIRE HARNESS (BELT - METER AND BODY GROUND)
E110282E04
  1. Disconnect the F12 belt connector.

  1. Disconnect the C8 meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    F12-1 - C8-11
    Below 1 Ω
    F12-2 - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY