Warning/Indicator Lights
Item
| Signal Description
|
TURN
| Blinks when receiving signal that turn signal switch or hazard warning signal switch is ON
|
BEAM
| Illuminates when headlight dimmer switch is set to HI BEAM or FLASH position
|
CHARGE
| Illuminates when receiving malfunction signal from generator
|
OIL PRESSURE
| Illuminates when receiving "oil pressure is abnormally low (pressure switch is ON)" signal
|
MIL
| Illuminates when receiving malfunction signal from ECM
|
DOOR
| Illuminates when receiving each door courtesy light switch signal
|
DRIVER SEAT BELT
| Blinks when driver's seat belt buckle switch is ON (unfastened)
|
PASSENGER SEAT BELT*1
| Blinks when passenger's seat belt buckle switch is ON (unfastened)
|
BRAKE
| Illuminates when receiving signal that parking brake switch is ON, brake fluid warning switch is ON, or vacuum warning switch is ON
|
ABS*2
| Illuminates when receiving malfunction signal from skid control ECU with actuator
|
GLOW*3
| Illuminates when receiving "engine is too cold to start (glow heater is ON)" signal from ECM
|
FUEL FILTER*3
| Illuminates when fuel filter is clogged and blinks when certain amount of water is accumulated at bottom of fuel filter
|
SRS*4
| Illuminates when receiving malfunction signal from center airbag sensor assembly
|
FUEL
| Illuminates when receiving fuel empty signal from fuel sender gauge
|
T-BELT*3
| Illuminates when odometer's display is 150,000 km
|
4WD*5
| Illuminates when changing drivetrain from 2WD to 4WD
|
ATF TEMP*6
| Illuminates when receiving "ATF temperature is too high" signal from ECM*10 (TCM*11)
|
P*7
| Illuminates when receiving P signal from PNP switch
|
R*7
| Illuminates when receiving R signal from PNP switch
|
N*7
| Illuminates when receiving N signal from PNP switch
|
D*7
| Illuminates when receiving D signal from shift control ECU
|
4*7
| Illuminates when receiving 4 signal from shift control ECU
|
3*7
| Illuminates when receiving P signal from PNP switch*6 Illuminates when receiving 3 signal from shift control ECU*9
|
2*7
| Illuminates when receiving 2 signal from PNP switch
|
L*7
| Illuminates when receiving L signal from PNP switch
|
A/T P*6
| Illuminates when receiving "transfer shift lever is on N and A/T shift lever is on P" signal
|
CRUISE*8
| Illuminates when receiving "cruise control system is operating properly" signal from ECM
|
TAIL*9
| Illuminates when light control switch is set to TAIL or HEAD position
|
FRONT FOG*12
| Illuminates when front fog light switch is ON
|
REAR FOG*13
| Illuminates when rear fog light switch is ON
|
REAR DIFF. LOCK*14
| Illuminates when receiving "rear differential lock" signal from 4WD control ECU
|
OIL LEVEL*15
| Illuminates when receiving "amount of engine oil is not sufficient" signal for engine oil level sensor
|
OIL CHANGE*16
| Illuminates when the receiving "oil change" signal from ECM
|