FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SEAT ASSEMBLY |
![]() |
Pull the inner belts out from the bottom of the seat cushion.
Remove the 4 bolts.
w/ Occupant detection sensor:
Disconnect the connector under the seat.
Remove the seat.
| 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
![]() |
Detach the clamp.
![]() |
Detach the wire harness from the clamp.
Remove the nut and seat belt.
Remove the buckle cover.
| 4. REMOVE FRONT SEAT INNER WITH CENTER BELT ASSEMBLY RH |
![]() |
Remove the bolt and seat belt.