CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL TIGHT PLUG |
![]() |
Apply adhesive to a new tight plug.
Using SST and a hammer, tap in the tight plug as shown in the illustration.

| 2. INSTALL STUD BOLT |
Install the stud bolts as shown in the illustration.

| 3. INSTALL RING PIN |
Using a plastic hammer, tap in a new ring pin until it stops.

| 4. INSTALL SEMICIRCULAR PLUG |
Remove any old packing (FIPG) material.
![]() |
Apply seal packing to the semicircular plug as shown in the illustration.
Install the semicircular plug to the cylinder head.
| 5. INSTALL COMBUSTION CHAMBER SUB-ASSEMBLY |
![]() |
Select the number of shim, depending on the table below.
| Number Mark of Cylinder Head | Number of Shim |
| 1 | 0 |
| 2 | 0 |
| 1 | |
| 3 | 1 |
| 2 |
Align the combustion chamber knock pin with the cylinder head notch.
![]() |
Using a plastic-faced hammer, tap in the combustion chamber.
![]() |
Using a dial indicator, check the combustion chamber protrusion.
| 6. INSTALL VALVE STEM OIL SEAL |
![]() |
Using SST, push in a new oil seal.
| 7. INSTALL INTAKE VALVE |
Install the valve, spring seat plate washer, valve spring and spring retainer.
![]() |
Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.
![]() |
Using a 5 mm pin punch and plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
| 8. INSTALL EXHAUST VALVE |
Install the valve, spring seat, valve spring and spring retainer.
![]() |
Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.
![]() |
Using a 5 mm pin punch and plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
| 9. INSTALL VALVE LIFTER |
Install the valve lifter and shim.
Check that the valve lifter rotates smoothly by hand.