FRONT SEAT INNER BELT ASSEMBLY > INSPECTION |
| 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) |
![]() |
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Seat belt is unfastened | Below 1 Ω |
| 1 - 2 | Seat belt is fastened | 1 MΩ or higher |
| 2. INSPECT OCCUPANT DETECTION SENSOR |
![]() |
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | More than 147 N (15 kgf, 33 lbf) of force applied to occupant detection sensor | Below 100 Ω |
| 1 - 2 | No force applied to occupant detection sensor | 1 MΩ or higher |
| 3. INSPECT FRONT SEAT INNER BELT ASSEMBLY (Passenger Side) |
![]() |
Measure the resistance of the buckle switch.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Seat belt is unfastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor | Below 100 Ω |
| 1 - 2 | Seat belt is fastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor | 1 MΩ or higher |
| 4. INSPECT PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY |
![]() |
Check the illumination area of the seat belt warning light.
| Measurement Condition | Specified Condition |
| Battery positive (+) → 3 (IG) Battery negative (-) → 2 (SW), 1(GND) | Illuminates |