Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type)

FRONT SEAT INNER BELT ASSEMBLY (for 2 Person Bench Seat Type) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


B085672E02
  1. Measure the resistance of the buckle switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened
    Below 1 Ω
    1 - 2
    Seat belt is fastened
    1 MΩ or higher

    If the result is not as specified, replace the belt assembly.



2. INSPECT OCCUPANT DETECTION SENSOR


E169498E03
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    More than 147 N (15 kgf, 33 lbf) of force applied to occupant detection sensor
    Below 100 Ω
    1 - 2
    No force applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the occupant detection sensor (front seat cushion pad).



3. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Passenger Side)


B089938E02
  1. Measure the resistance of the buckle switch.

    HINT:
    Before performing the buckle switch check, perform the previous step (inspect occupant detection sensor) to make sure the occupant detection sensor is functioning normally.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Seat belt is unfastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
    Below 100 Ω
    1 - 2
    Seat belt is fastened and more than 147 N (15 kgf, 33 lbf) of force is applied to occupant detection sensor
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.



4. INSPECT PASSENGER SEAT BELT WARNING LIGHT ASSEMBLY


B089939E01
  1. Check the illumination area of the seat belt warning light.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 3 (IG)
    Battery negative (-) → 2 (SW), 1(GND)
    Illuminates

    If the result is not as specified, replace the passenger seat belt warning light assembly.