Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  1. Inspect the fuses and relays related to this system before inspecting the suspected areas below.
  1. If the malfunction still exists even after checking and confirming that all the circuits are normal, replace the A/C amplifier.


A/C system 
Symptom
Suspected Area
See page
All functions of A/C system do not operate
1. A/C control assembly
Click here
2. A/C amplifier assembly
Click here
3. Wire harness
-
Air flow control: No blower operation
1. Blower resistor
Click here
2. Blower w/ fan motor sub-assembly
Click here
3. A/C control assembly
Click here
4. Wire harness
-
Air flow control: No blower control
1. Blower resistor
Click here
2. A/C control assembly
Click here
3. Wire harness
-
Air flow control: Insufficient air comes out
1. Blower w/ fan motor sub-assembly
Click here
2. Blower resistor
Click here
3. A/C control assembly
Click here
4. Wire harness
-
Temperature control: No cool air comes out
1. Volume of refrigerant
Click here
2. Drive belt (1TR-FE)
Click here
3. Drive belt (2TR-FE)
Click here
4. Drive belt (1KD-FTV)
-
5. Drive belt (2KD-FTV)
Click here
6. Drive belt (1GR-FE)
Click here
7. Refrigerant pressure
Click here
8. Cooler compressor assembly (TR Series Engine)
Click here
9. Cooler compressor assembly (1KD-FTV, 2KD-FTV)
Click here
10. Cooler compressor assembly (1GR-FE)
-
11. Magnet clutch relay*1
Click here
12. A/C pressure switch
Click here
13. Air mix control cable
-
14. A/C control assembly
Click here
15. Wire harness
-
Temperature control: Output air is warmer or cooler than set temperature or response is slow
1. Air mix control cable
-
2. A/C control assembly
Click here
Temperature control: No temperature control
1. Air mix control cable
-
2. A/C control assembly
Click here
No air inlet control
1. Air inlet damper control cable
-
2. A/C control assembly
Click here
No air outlet control
1. Mode control cable
-
2. A/C control assembly
Click here
Engine idle-up does not occur, or is continuous
1. Cooler compressor assembly (TR Series Engine)
Click here
2. Cooler compressor assembly (1KD-FTV, 2KD-FTV)
Click here
3. Cooler compressor assembly (1GR-FE)
-
4. A/C control assembly
Click here
5. A/C amplifier assembly
Click here
6. ECM
Click here
PTC heater does not function*1, *2
1. PTC heater relay
Click here
2. Heater switch assembly
Click here
3. Air mix control cable
-
4. A/C control assembly
Click here
5. A/C unit assembly (Max. HOT switch)
Click here
6. A/C amplifier assembly
Click here
7. ECM
Click here
8. Wire harness
-
9. Quick heater and accessory assembly
Click here

HINT:
  1. *1: w/ PTC heater
  1. *2: The PTC heater operation may be stopped when the electrical load is large on the entire vehicle.