Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT (for Automatic Air Conditioning System)

AIR CONDITIONING UNIT (for Automatic Air Conditioning System) > REASSEMBLY

for Preparation Click here



1. INSTALL EVAPORATOR TEMPERATURE SENSOR


E173257E01

NOTICE:
If reusing the evaporator, do not insert the sensor at a location where the sensor was previously inserted. Insert the sensor within range C shown in the illustration.

  1. Insert the evaporator temperature sensor as shown in the illustration to install it.



2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


E173253
  1. Install the cooler evaporator to the case.

  1. Attach the temperature sensor clamp.



    E173252
  1. Attach the 2 claws to install the cover.

  1. Install the 4 screws.



3. INSTALL COOLER EXPANSION VALVE


E111000E01
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the cooler evaporator.

  1. Using a 4 mm socket hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }



4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY


E173260
  1. Attach the evaporator case to the blower case.

  1. Install the heater radiator with the screw.



5. INSTALL MODE DAMPER SERVO SUB-ASSEMBLY


E173248
  1. Set the damper servo so that the cutout part engages with the tooth of the gear to install the damper servo.

  1. Install the 3 screws.



6. INSTALL AIR MIX DAMPER SERVO SUB-ASSEMBLY


E173250
  1. Set the damper servo so that the cutout part engages with the tooth of the gear to install the damper servo.

  1. Install the 3 screws.



7. INSTALL BLOWER ASSEMBLY
  1. Attach the blower assembly to the air conditioning radiator assembly.



    E175031
  1. Install the blower with the 2 screws.