DTC P0776 Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0776 | Gear required by the ECM does not match the actual gear when driving (2 trip detection logic) |
|
| Item | Test Details | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate shift solenoid valve and set each shift position by yourself [Vehicle Condition] 50 km/h (31 mph) or less [Other information]
| Possible to check the operation of shift solenoid valves |
| ECM gear shift command | 1st | 2nd | 3rd | 4th | 5th |
| Shift solenoid valve SL2 | ON | ON | ON | ON | OFF |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0776) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only P0776 is output | A |
| P0776 and other DTCs | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
![]() |
Remove the test plug on the transmission case center right side and connect SST.
Connect the intelligent tester to the DLC3.
Start the engine and warm it up.
Measure the line pressure with SST.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
Follow the instructions on the tester and perform the Active Test.
Measure the line pressure with SST.
| Item | Test Details | Diagnostic Note |
| Control the Line Pressure Up* | [Test Details] Operate shift solenoid SLT and raise line pressure [Vehicle Condition]
| - |
|
| ||||
| OK | |
| 3.INSPECT SHIFT SOLENOID VALVE SL2 |
![]() |
Remove the shift solenoid valve SL2.
Measure the resistance of the solenoid valve.
Connect the positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector, then check the movement of the valve.
Check the operating noise of terminal 1 of the solenoid valve.
|
| ||||
| OK | |
| 4.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | ||
| ||