Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A105095E02
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    2.32 to 2.59 Ω at 20°C (68°F)
    1 - 2
    0.310 to 0.326 kΩ at 80°C (176°F)

    If the result is not as specified, replace the engine coolant temperature sensor.

    NOTICE:
    When checking the sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.