DTC P0340 Camshaft Position Sensor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | When either condition below is met:
|
|

| Item | Content |
| Terminal | (b) G+ - G- |
| Tester Range | 5 V/DIV., 20 msec./DIV. |
| Condition | Cranking or idling |
| 1.INSPECT CAMSHAFT POSITION SENSOR (RESISTANCE) |
![]() |
Disconnect the C1 sensor connector.
Measure the resistance of the position sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Approx. 20°C (68°F) | 950 to 1,250 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
![]() |
Disconnect the C1 sensor connector.
Disconnect the E7 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C1-1 - E7-23 (G+) | Below 1 Ω |
| C1-2 - E7-31 (G-) | Below 1 Ω |
| Tester Connection | Specified Condition |
| C1-1 or E7-23 (G+) - Body ground | 10 kΩ or higher |
| C1-2 or E7-31 (G-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CAMSHAFT POSITION SENSOR (INSTALLATION) |
![]() |
Check the sensor installation.
|
| ||||
| OK | |
| 4.CHECK PUMP DRIVE SHAFT PULLEY |
Check the teeth of the pump drive shaft pulley.
|
| ||||
| OK | ||
| ||