Home › ENGINE ยท 2KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (w/ EGR Cooler)

DTC    P0500    Vehicle Speed Sensor Malfunction

for Preparation Click here


DESCRIPTION

The vehicle speed sensor outputs a 4-pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of these pulse signals.

G036461E02


DTC No.
DTC Detection Condition
Trouble Area
P0500
Conditions (a), (b) and (c) continue for 8 seconds or more:
(2 trip detection logic)
(a) Engine coolant temperature is more than 70°C (158°F)
(b) Engine speed is between 1,500 rpm and 4,000 rpm
(c) No speed signal is input to ECM
  1. Open or short in speed sensor circuit
  2. Speed sensor
  3. Combination meter
  4. ECM
Conditions (a), (b) and (c) continue for 5 seconds or more:
(2 trip detection logic)
(a) Vehicle running
(b) Under fuel-cut operation
(c) No speed signal is input to ECM

WIRING DIAGRAM


A154736E01


INSPECTION PROCEDURE

NOTICE:
If the ECM is replaced, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.CHECK COMBINATION METER (OPERATION OF SPEEDOMETER)
  1. Drive the vehicle.

  1. Check the speedometer reading in the combination meter.

    HINT:
    If the vehicle speed sensor has any malfunctions, the speedometer shows abnormal readings.

    OK:
    Speedometer operates normally.



NG
CHECK SPEEDOMETER CIRCUIT (INCLUDING SPEED SENSOR)
OK


2.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine and turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine / Data List / Vehicle Speed.

  1. While the vehicle is running, check the vehicle speed at an engine speed of 2,000 rpm or more.

    OK:
    Same value as actual vehicle speed.



YES
CHECK FOR INTERMITTENT PROBLEMS
NO


3.INSPECT ECM (SPD SIGNAL)


    G036576E10
  1. While idling the engine, check the waveform of the ECM connectors using an oscilloscope.

    1. Move the shift lever to N.

    2. Jack up the vehicle.

    3. Turn the ignition switch ON.

    4. Measure the voltage of the ECM connectors as the wheel is turned slowly.

      Standard:
      Tester Connection
      Specified Condition
      E6-17 (SPD) - E7-7 (E1)
      Correct waveform is shown

      Tool Setting
      Condition
      5 V/DIV., 20 msec./DIV.
      Turn the rear wheel slowly

      HINT:
      When the wheel is turning slowly, voltage is output intermittently.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM