DTC P0617 Starter Relay Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0617 | When conditions (a), (b) and (c) are met and battery (+B) voltage of 10.5 V or more is applied for 20 seconds. (a) Vehicle speed is greater than 20 km/h (12 mph) (b) Engine revolution is greater than 1,000 rpm (c) STA signal ON |
|

| 1.READ DATA LIST (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the result when the ignition switch is turned to ON and START.
| Ignition Switch Position | STA Signal | Proceed to |
| ON → START | for A/T: Display does not change from OFF → ON | A |
| ON → START | for M/T: Display does not change from OFF → ON | B |
| ON → START | Display changes from OFF → ON | C |
|
| ||||
|
| ||||
| A | |
| 2.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Move the shift lever to the P or N position.
Disconnect the N1 Park/Neutral Position (PNP) switch connector.
Measure the resistance of the PNP switch.
| Tester Connection | Shift Position | Specified Condition |
| 4 (B) - 5 (L) | P or N | Below 1 Ω |
| 4 (B) - 5 (L) | Except P or N | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Measure the resistance of the I6 ignition switch.
| Tester Connection | Switch Condition | Specified Condition |
| 5 - 7 | LOCK | 10 kΩ or higher |
| 5 - 7 | START | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK IF DTC OUTPUT RECURS |
Clear the DTCs.
Drive the vehicle at more than 40 km/h (25 mph) for 20 seconds or more.
Connect the intelligent tester to the DLC3.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTC.
| Display (DTC Output) | Proceed to |
| P0617 is output again | A |
| No DTC is output | B |
|
| ||||
| A | ||
| ||