TAIL GATE > REMOVAL |
| 1. REMOVE TAIL GATE SERVICE HOLE COVER |
![]() |
for J Deck:
Remove the 8 screws and cover.
for A Deck:
Remove the 10 screws and cover.
| 2. REMOVE REAR BODY TAIL GATE LATCH ASSEMBLY (for J Deck) |
![]() |
for LH Side:
Remove the 2 bolts and rear body tail gate latch.
for RH Side:
| 3. REMOVE TAIL GATE HANDLE ASSEMBLY (for A Deck, w/o Key Cylinder) |
![]() |
Disconnect the 2 control rods as indicated by the black arrows in the illustration.
Remove the 2 screws indicated by the white arrows. Then remove the handle.
| 4. REMOVE KEY CYLINDER (for A Deck, w/ Key Cylinder) |
![]() |
Disconnect the tail gate lock control link as indicated by the black arrow in the illustration.
Remove the 2 bolts indicated by the white arrows. Then remove the key cylinder.
| 5. REMOVE LUGGAGE COMPARTMENT LOCK CYLINDER RETAINER (for A Deck, w/ Key Cylinder) |
![]() |
Detach the 2 claws and remove the retainer.
| 6. REMOVE TAIL GATE LOCK ASSEMBLY LH (for A Deck) |
w/ Key Cylinder:
![]() |
Remove the 2 bolts.
Disconnect the control cable and remove the tail gate lock.
![]() |
w/o Key Cylinder:
Remove the 2 bolts and lock.
Remove the control rod.
| 7. REMOVE TAIL GATE LOCK ASSEMBLY RH (for A Deck) |
| 8. REMOVE TAIL GATE HANDLE ASSEMBLY (for A Deck, w/ Key Cylinder) |
![]() |
Disconnect the control rod as indicated by the black arrows in the illustration.
Remove the 2 bolts indicated by the white arrows. Then remove the handle.
| 9. REMOVE TAIL GATE LOCK CONTROL ASSEMBLY (for A Deck, w/ Key Cylinder) |
![]() |
Detach the cable clamp.
Loosen the bolt.
Remove the 2 nuts.
![]() |
Remove the tail gate lock control assembly with the tail gate lock control link and 2 cables connected.
Remove the bolt from the tail gate lock control assembly.
| 10. REMOVE TAIL GATE PROTECTOR RH (for A Deck, w/ Key Cylinder) |
![]() |
Detach the 3 claws and remove the tail gate protector.
| 11. REMOVE REAR DOOR NO. 1 LOCK REMOTE CONTROL CABLE ASSEMBLY (for A Deck, w/ Key Cylinder) |
![]() |
Remove the remote control cable.
| 12. REMOVE REAR DOOR NO. 2 LOCK REMOTE CONTROL CABLE ASSEMBLY (for A Deck, w/ Key Cylinder) |
![]() |
Remove the remote control cable.
| 13. REMOVE TAIL GATE LOCK CONTROL LINK (for A Deck, w/ Key Cylinder) |
![]() |
Remove the tail gate lock control link.
| 14. REMOVE CENTER STOP LIGHT ASSEMBLY (w/ Center Stop Light) |
![]() |
Disconnect the connector.
Detach the clamp.
Detach the 4 claws and remove the center stop light.
| 15. REMOVE TAIL GATE STAY ASSEMBLY |
for LH Side:
![]() |
Remove the 2 screws and stay.
for RH Side: