TRANSMISSION CONTROL CABLE > REPLACEMENT |
| 1. REMOVE TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
w/ M/T:
Twist the knob in the direction indicated by the arrow and remove it.
w/ 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow and remove it.
| 2. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY |
![]() |
Detach the 4 claws and remove the hole cover.
| 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Detach the 12 claws and remove the console panel.
| 4. REMOVE CONSOLE BOX ASSEMBLY |
![]() |
Remove the 4 screws <F> and 2 bolts <E>.
Using a clip remover, remove the 2 clips and console box.
| 5. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Move the shift lever to L.
Disconnect the control cable from the shift lever.
Remove the lock clip and disconnect the control cable from the bracket.
![]() |
Remove the 2 nuts and disconnect the control cable from the vehicle body.
![]() |
Remove the nut and disconnect the control cable from the vehicle body.
![]() |
Remove the nut and clip and disconnect the control cable.
| 6. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY |
Install the control cable with the nut.
![]() |
Connect the control cable to the vehicle body with the nut.
![]() |
Connect the control cable to the vehicle body with the 2 nuts.
![]() |
Connect the control cable to the bracket with the lock clip.
Move the shift lever to L.
Install the control cable to the shift lever.
| 7. ADJUST SHIFT LEVER POSITION |
Move the shift lever to N.
![]() |
Remove the nut and disconnect the control cable.
![]() |
Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.
| 8. INSPECT SHIFT LEVER POSITION |
Move the shift lever to N.
![]() |
Remove the nut and disconnect the control cable.
![]() |
Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
While holding the control shaft lever slightly toward the R position side, connect the cable with the nut.
| 9. INSTALL CONSOLE BOX ASSEMBLY |
![]() |
Install the console box with the 2 clips, 4 screws <F> and 2 bolts <E>.
| 10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Attach the 12 claws to install the console panel.
| 11. INSTALL PARKING BRAKE HOLE COVER SUB-ASSEMBLY |
![]() |
Attach the 4 claws to install the hole cover.
| 12. INSTALL TRANSFER SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
w/ M/T:
Twist the knob in the direction indicated by the arrow to install it.
w/ 4WD:
Twist the transfer shift lever knob in the direction indicated by the arrow to install it.