Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > DISASSEMBLY

for Preparation Click here


HINT:
When removing the finish plate and name plate, heat the finish plate and name plate using a heat light.

Standard Heating temperature:
Item
Specified Condition
Finish plate, name plate
20 to 30°C (68 to 86°F)



1. REMOVE NO. 1 RADIATOR GRILLE RETAINER
  1. Remove the 5 screws and retainer.



2. REMOVE RADIATOR GRILLE FINISH PLATE LH (w/ Plated Moulding)


    B085204E01
  1. Using a heat light, heat the finish plate.

  1. Pull off the finish plate by cutting the double-sided tape with a knife.

    NOTICE:
    Be careful not to damage the radiator grille.

  1. Remove the finish plate.



3. REMOVE RADIATOR GRILLE FINISH PLATE RH (w/ Plated Moulding)

HINT:
Use the same procedures described for the LH side.



4. REMOVE RADIATOR GRILLE NAME PLATE (for 1GR-FE)


B112761E01
  1. Remove the 2 spring nuts.

  1. Using a heat light, heat the name plate.

    NOTICE:
    Do not heat the name plate excessively.

  1. Pull off the name plate by cutting the double-sided tape with a knife.

    NOTICE:
    Be careful not to damage the radiator grille.

  1. Remove the name plate.



5. REMOVE RADIATOR GRILLE EMBLEM


B085201E01
  1. Using a screwdriver, detach the 3 claws and remove the emblem from the radiator grille.



6. REMOVE FOG LIGHT ASSEMBLY LH WITH BRACKET (w/ Fog Light)


    B085698E01
  1. Remove the 2 bolts and fog light.



7. REMOVE FOG LIGHT ASSEMBLY RH WITH BRACKET (w/ Fog Light)


    B087792E01
  1. Remove the 2 bolts and fog light.



8. REMOVE FRONT BUMPER EXTENSION LH (w/ Over Fender)


B085198E01
  1. Using a screwdriver, detach the 6 retainers and remove the extension.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE FRONT BUMPER EXTENSION RH (w/ Over Fender)

HINT:
Use the same procedures described for the LH side.



10. REMOVE FRONT BUMPER GARNISH (w/ Garnish)

HINT:
Tape the screwdriver tip before use.



    B122880E01
  1. Using a screwdriver, remove the 3 retainers.



    B122879E01
  1. Using a screwdriver, remove the 10 retainers and garnish.



11. REMOVE FRONT BUMPER HOLE COVER LH
  1. Using a screwdriver, remove the clip and hole cover.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE FRONT BUMPER HOLE COVER RH

HINT:
Use the same procedures described for the LH side.



13. REMOVE NO. 2 FRONT BUMPER EXTENSION INSERT LH
  1. Remove the screw and extension insert.



14. REMOVE NO. 2 FRONT BUMPER EXTENSION INSERT RH
  1. Remove the screw and extension insert.