FRONT BUMPER > REASSEMBLY |
| Item | Specified Condition |
| Radiator grille, finish plate and name plate | 20 to 30°C (68 to 86°F) |
| 1. INSTALL NO. 2 FRONT BUMPER EXTENSION INSERT LH |
Install the extension insert with the screw.
| 2. INSTALL NO. 2 FRONT BUMPER EXTENSION INSERT RH |
Install the extension insert with the screw.
| 3. INSTALL FRONT BUMPER HOLE COVER LH |
Install the hole cover with the clip.
| 4. INSTALL FRONT BUMPER HOLE COVER RH |
Install the hole cover with the clip.
| 5. INSTALL FRONT BUMPER EXTENSION LH (w/ Over Fender) |
![]() |
Install the extension with the 6 retainers.
| 6. INSTALL FRONT BUMPER EXTENSION RH (w/ Over Fender) |
| 7. INSTALL FOG LIGHT ASSEMBLY LH WITH BRACKET (w/ Fog Light) |
![]() |
Install the fog light with the 2 bolts.
| 8. INSTALL FOG LIGHT ASSEMBLY RH WITH BRACKET |
![]() |
Install the fog light with the 2 bolts.
| 9. INSTALL RADIATOR GRILLE EMBLEM |
![]() |
Attach the 3 claws to install the emblem.
| 10. INSTALL RADIATOR GRILLE FINISH PLATE LH (w/ Plated Moulding) |
Clean the grille surface:
Using a heat light, heat the grille surface.
Remove the double-sided tape from the grille.
Wipe off the stains with cleaner.
If reusing the finish plate:
Using a heat light, heat the finish plate.
Remove the double-sided tape from the finish plate.
Wipe off the stains with cleaner.
![]() |
Apply new double-sided tape to the finish plate as shown in the illustration.
Install the finish plate.
Remove the peeling paper from the finish plate.
Install the finish plate to the radiator grille.
| 11. INSTALL RADIATOR GRILLE FINISH PLATE RH (w/ Plated Moulding) |
| 12. INSTALL NO. 1 RADIATOR GRILLE RETAINER |
Install the retainer with the 5 screws.