DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0741 | Lock-up does not occur when driving in the lock-up range (normal driving at 80 km/h [50 mph]), or lock-up remains ON in the lock-up OFF range (2-trip detection logic) |
|
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
Enter the following menus: Powertrain / ECT / DTC / Current or Pending.
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only P0741 is output | A |
| P0741 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE SL |
![]() |
Remove the shift solenoid valve SL.
Measure the resistance of the solenoid value.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid SL connector - Shift solenoid SL body | 20°C (68°F) | 11 to 15 Ω |
Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
Check the operating noise of the solenoid valve.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly.
|
| ||||
| OK | ||
| ||