DTC P0500 Vehicle Speed Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0500 | All conditions below are detected 500 times or more continuously (2 trip detection logic): (a) No signal from vehicle speed sensor (SPD1) is input to TCM while 48 pulses of speed sensor (SP2) signal are sent (b) Vehicle speed is 9 km/h (.6 mph) or more for at least 4 seconds (c) PNP switch is off (shift lever not on P or N) (d) Transfer shift lever is not on N |
|

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Enter the following menus: Powertrain / ECT / Data List / Vehicle Speed.
Check the vehicle speed at an engine speed of 2000 rpm or more while the vehicle is running.
|
| ||||
| OK | |
| 2.CHECK SPEEDOMETER OPERATION |
Check the speedometer reading in the combination meter.
|
| ||||
| OK | |
| 3.CHECK TCM (SPD1 SIGNAL) |
![]() |
![]() |
While idling, check the waveform of the TCM connector using an oscilloscope.
Move the shift lever to N.
Jack up one of the rear wheels.
Turn the ignition switch to ON.
Measure the voltage of the TCM connector as the wheel is turned slowly.
| Item | Content |
| Tester Connection | T17-25 (SPD1) - Body ground |
| Tool Setting | 5 V/DIV., 20 msec./DIV. |
| Condition | Rear wheel turning slowly |
|
| ||||
| OK | ||
| ||