AUTOMATIC TRANSMISSION SYSTEM > Stop Light Switch Circuit |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF | Brake pedal is
| - |
| 1.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the S14 stop light switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin pushed (pedal released) | 10 kΩ or higher |
| 3 - 4 | Pin not pushed (pedal depressed) | 10 kΩ or higher |
| 1 - 2 | Pin not pushed (pedal depressed) | Below 1 Ω |
| 3 - 4 | Pin pushed (pedal released) | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (ECM - BATTERY) |
![]() |
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E10-4 (STP) - Body ground | Brake pedal is depressed | 7.5 to 14 V |
| E10-4 (STP) - Body ground | Brake pedal is released | Below 1 V |
|
| ||||
| OK | ||
| ||