DTC P2716/77 Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |
![]() |
| DTC Code | DTC Detection Condition | Trouble Area |
| P2716/77 | ECM detects shift solenoid valve SLT circuit malfunction for 1 sec. or more (1 trip detection logic) |
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT) |
![]() |
Disconnect the E1 wire connector.
Measure the resistance of the transmission wire.
| Tester Connection | Condition | Specified Condition |
| 2 (SLT+) - 6 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| 2 (SLT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| 6 (SLT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (SHIFT SOLENOID VALVE SLT - ECM) |
![]() |
Disconnect the E11 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| E11-12 (SLT+) - E11-13 (SLT-) | 20°C (68°F) | 5.0 to 5.6 Ω |
| E11-12 (SLT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| E11-13 (SLT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE SLT |
![]() |
Remove the shift solenoid valve SLT.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
![]() |
Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
![]() |
| Item | Content |
| Tester Connection | E11-12 (SLT+) - E11-13 (SLT-) |
| Tool Setting | 5 V/DIV., 1 msec./DIV. |
| Condition | Engine is idling |
|
| ||||
| OK | ||
| ||