Home › TRANSMISSION · A343E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

DTC    P0722/61    Output Speed Sensor Circuit No Signal

for Preparation Click here


DESCRIPTION

The speed sensor (SP2) detects the rotation speed of the transmission output shaft and sends signals to the ECM. The ECM determines the vehicle speed based on these signals.
AC voltage is generated in the speed sensor (SP2) coil as the rotor mounted on the output shaft rotates, and this voltage is sent to the ECM.
The gear shift point and lock-up timing are controlled by the ECM based on the signals from the output speed sensor and throttle position sensor.

DTC Code
DTC Detection Condition
Trouble Area
P0722/61
  1. All conditions below are detected 500 times or more continuously (2 trip detection logic):
    1. No signal from speed sensor (SP2) is input to ECM while 4 pulses of No. 1 vehicle speed sensor signal are sent
    2. Vehicle speed is 9 km/h (5.6 mph) or more for at least 4 sec.
    3. Park/neutral position switch is OFF
  1. Open or short in speed sensor (SP2) circuit
  2. Speed sensor (SP2)
  3. ECM

MONITOR DESCRIPTION

The output speed sensor (SP2) monitors the output shaft speed. The ECM controls the gear shift point and the lock-up timing based on the signals from the output speed sensor (SP2) and throttle position sensor.
If the ECM detects no signal from the output speed sensor (SP2) even while the vehicle is moving, the ECM will conclude that the output shaft speed sensor (SP2) is malfunctioning. The ECM will illuminate the MIL and set the DTC.

WIRING DIAGRAM


C155187E15


INSPECTION PROCEDURE

1.CHECK SPEED SENSOR (SP2) (INSTALLATION)


    C159067E02
  1. Check the speed sensor installation.

    OK:
    Installation bolt is tightened properly and there is no clearance between sensor and transmission case.



NG
SECURELY INSTALL SPEED SENSOR OR REPLACE SPEED SENSOR
OK


2.INSPECT SPEED SENSOR (SP2)
C159420E04
  1. Disconnect the T7 sensor connector from the transmission.



    C170571E01
  1. Measure the resistance of the sensor.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    560 to 680 Ω


    HINT:
    C192331E02
    Reference: Inspect using an oscilloscope.
    Check the waveform of the ECM connector.

    OK:
    Refer to illustration
    Item
    Content
    Tester Connection
    E11-35 (SP2+) - E11-27 (SP2-)
    Tool Setting
    2 V/DIV., 2 msec./DIV.
    Condition
    Vehicle speed 20 km/h (12 mph)



NG
REPLACE SPEED SENSOR
OK


3.CHECK WIRE HARNESS (SPEED SENSOR (SP2) - ECM)


    C192332E02
  1. Disconnect the E11 ECM connector.

  1. Measure the resistance of the wire harness side connector.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E11-35 (SP2+) - E11-27 (SP2-)
    20°C (68°F)
    560 to 680 Ω
    E11-35 (SP2+) - Body ground
    20°C (68°F)
    10 kΩ or higher
    E11-27 (SP2-) - Body ground
    20°C (68°F)
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM