DTC P0710/38 Transmission Fluid Temperature Sensor "A" Circuit |
DTC P0712/38 Transmission Fluid Temperature Sensor "A" Circuit Low Input |
DTC P0713/38 Transmission Fluid Temperature Sensor "A" Circuit High Input |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0710/38 |
|
|
| P0712/38 | ATF temperature sensor resistance is less than 79 Ω for 0.5 sec. or more (1 trip detection logic) |
|
| P0713/38 | ATF temperature sensor resistance is more than 156 kΩ for 15 minutes or more after the engine starts DTC is detected for 0.5 sec. or more (1 trip detection logic) |
|

| Item | Measurement Item/ Range (Display) | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 3 | ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If value is -40°C (-40°F) or 215°C (419°F), ATF temperature sensor circuit is opened or short circuited |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.INSPECT ATF TEMPERATURE SENSOR |
![]() |
Disconnect the A2 ATF temperature sensor connector from the transmission.
Measure the resistance of the temperature sensor.
| Tester Connection | Specified Condition |
| 1 - 2 | 79 Ω to 156 kΩ |
| 1 - Body ground | 1 MΩ or higher |
| 2 - Body ground | 1 MΩ or higher |
| ATF Temperature | Specified Condition |
| 20°C (68°F) | 10.3 to 13.9 kΩ |
| 110°C (230°F) | 0.68 to 0.88 kΩ |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (ATF TEMPERATURE SENSOR - TCM) |
![]() |
Disconnect the T19 TCM connectors.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| T19-24 (THOC) - T19-23 (E2) | 79 Ω to 156 kΩ |
| T19-24 (THOC) - Body ground | 10 kΩ or higher |
| T19-23 (E2) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||