STARTER (for 2.7 kW Type) > INSPECTION |
| 1. INSPECT STARTER ASSEMBLY |

Perform pull-in test.
Remove the nut, and then disconnect the field coil lead wire from terminal C.
Connect the battery to the magnet starter switch as shown in the illustration. Then check that the clutch pinion gear moves outward.
If the clutch pinion gear does not move, replace the magnet starter switch assembly.

Perform holding test.
When the battery is connected as above with the clutch pinion gear out, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.
If the clutch pinion gear moves inward, replace the magnet starter switch assembly.

Inspect clutch pinion gear return.
Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
If the clutch pinion gear does not return inward, replace the magnet starter switch assembly.

Perform operation test without load.
![]() |
Connect the field coil lead wire to terminal C with the nut.
Mount the starter in a vise between aluminum plates.
Connect the battery and an ammeter to the starter as shown in the illustration.

Check that the starter rotates smoothly and steadily while the pinion gear is moving outward. Then measure the current.
| 2. INSPECT STARTER ARMATURE ASSEMBLY |
Measure the resistance.
![]() |
Measure the resistance between any 2 segments of the commutator.
![]() |
Measure the resistance between each segment of the commutator and the armature coil core.
![]() |
Inspect circle runout.
Place the armature on V-blocks.
Using a dial gauge, measure the circle runout.
![]() |
Using a vernier caliper, measure the commutator diameter.
![]() |
Measure the undercut depth of the commutator.
Inspect the armature bearings.
Check that the armature bearings rotate smoothly.
If the result is not as specified, replace the armature assembly.
| 3. INSPECT STARTER YOKE ASSEMBLY |
![]() |
Inspect the field coil for an open circuit.
Measure the resistance between the lead wire and field coil brush lead.
![]() |
Inspect the ground.
Measure the resistance between the lead wire and starter yoke body, and between the brushes and starter yoke body
| 4. INSPECT BRUSH |
![]() |
Using a vernier caliper, measure the brush length.
| 5. INSPECT STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Inspect the brush insulation.
Using an ohmmeter, measure the resistance between the positive and negative brush holders.
![]() |
Take the pull scale reading the instant the brush spring separates from the brush.
| 6. INSPECT STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Rotate the pinion gear clockwise and check that it turns freely. Try to rotate the pinion gear counterclockwise and check that it locks.
If the result is not as specified, replace the starter clutch sub-assembly.
| 7. INSPECT MAGNET STARTER SWITCH ASSEMBLY |
Check if the pull-in coil has an open circuit.
![]() |
Measure the resistance between terminal 50 and terminal C.
Check if the hold-in coil has an open circuit.
![]() |
Measure the resistance between terminal 50 and the switch body.