Home › ENGINE ยท 2KD-FTV › STARTING › GLOW PLUG (w/ EGR Cooler)

GLOW PLUG (w/ EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE EGR COOLER
  1. Remove the EGR cooler (Click here).



3. REMOVE NO. 1 GLOW PLUG CONNECTOR
  1. Remove the bolt and No. 2 intake manifold stay.

  1. Remove the nut and wire harness.

  1. Remove the 4 screw grommets, 4 nuts and glow plug connector.



4. REMOVE NO. 1 INTAKE MANIFOLD INSULATOR


    A148177
  1. Remove the manifold insulator from the cylinder head.



5. REMOVE GLOW PLUG ASSEMBLY


    A148178
  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.