Home › ENGINE ยท 2KD-FTV › EMISSION CONTROL › EGR VALVE (w/o EGR Cooler)

EGR VALVE (w/o EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY


A098889E06
  1. Disconnect the manifold absolute pressure sensor connector.

  1. Disconnect the vacuum hose from the gas filter.

  1. Loosen the 2 clamps of the No. 1 and No. 2 air hoses.

  1. Remove the bolt and cleaner pipe together with the 2 air hoses.



3. REMOVE VACUUM SWITCHING VALVE BRACKET


A114169
  1. Remove the 2 connectors from the E-VRV and EGR valve.

  1. Disconnect the vacuum hoses from the 2 locations.

  1. Remove the 2 bolts and bracket.



4. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    A111790
  1. Disconnect the 2 connectors.



    A111832
  1. Remove the 2 bolts, 2 nuts, throttle body and gasket.



5. REMOVE THROTTLE BODY BRACKET


    A099620E01
  1. Remove the 3 bolts and bracket.



6. REMOVE INTAKE AIR CONNECTOR
  1. Remove the 2 nuts, bolt, air connector and gasket.



7. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY


    G037199E03
  1. Remove the 2 bolts, 2 nuts, pipe and 2 gaskets.



8. REMOVE EGR VALVE ASSEMBLY
  1. Remove the EGR valve and gasket.