VACUUM SWITCHING VALVE (w/ EGR Cooler) > INSPECTION |
| 1. INSPECT NO. 1 VACUUM SWITCHING VALVE (for EGR Cut) |
![]() |
Measure the resistance of the VSV.
| Tester Connection | Specified Condition |
| 1 - 2 | 37 to 44 Ω at 20°C (68°F) |
| 1 - Body Ground 2 - Body Ground | 1 MΩ or higher |
![]() |
Check operation of the VSV.
Attach a vacuum pump to port E, check that vacuum does not flow from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
![]() |
Apply battery voltage across terminals 1 and 2.
Attach a vacuum pump to port E, and check that vacuum flows from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
| 2. INSPECT NO. 2 VACUUM SWITCHING VALVE (for No. 2 EGR) |
![]() |
Measure the resistance of the VSV.
| Tester Connection | Specified Condition |
| 1 - 2 | 37 to 44 Ω at 20°C (68°F) |
| 1 - Body Ground 2 - Body Ground | 1 MΩ or higher |
![]() |
Check operation of the VSV.
Attach a vacuum pump to port E, and check that vacuum flows from the filter to port E.
If the result is not as specified, replace the vacuum switching valve.
![]() |
Apply battery voltage across terminals 1 and 2.
Attach a vacuum pump to port F, and check that vacuum flows from port E to port F.
If the result is not as specified, replace the vacuum switching valve.