Home › ENGINE ยท 1KD-FTV › INTAKE › TURBOCHARGER (w/ EGR Cooler)

TURBOCHARGER (w/ EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A099591E01
  1. Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112147E01



3. REMOVE FRONT WHEEL RH


4. REMOVE FRONT FENDER APRON SEAL UPPER
  1. Remove the 5 clips and apron seal.



5. REMOVE FRONT FENDER SEAL
  1. Remove the 5 clips and fender seal.



6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Disconnect the front pipe from the outlet pipe and remove the gasket.

  1. Remove the front pipe from the pipe support.



7. REMOVE AIR CLEANER ASSEMBLY


A099628E02
  1. Disconnect the MAF meter connector and remove the clamp.

  1. Loosen the hose clamp of the compressor inlet elbow.

  1. for Ventilation Hose Type:
    Disconnect the ventilation hose.

  1. Remove the 2 bolts and air cleaner.



8. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A110362
  1. Remove the 3 bolts, 2 nuts and cover.



9. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR
  1. Remove the intercooler assembly with intake air connector (Click here).



10. REMOVE COMPRESSOR INLET ELBOW


    A110341
  1. for Ventilation Pipe Type:
    Remove the ventilation pipe.

    1. Move the clamp so that the hose can be disconnected.

    2. Remove the ventilation pipe.

  1. Disconnect the 2 connectors from the turbocharger.

  1. Remove the wire clamp's clip from the inlet elbow.

  1. Remove the 2 nuts, inlet elbow and gasket.



11. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


A110342
  1. Remove the 2 bolts and heat insulator.



12. REMOVE NO. 1 TURBO INSULATOR
  1. Remove the bolt and insulator.



13. REMOVE NO. 1 TURBO WATER HOSE


A098815E01
  1. Move the 2 clamps and disconnect the 2 hoses.



14. REMOVE TURBINE OUTLET ELBOW


A098816E01
  1. Remove the 3 nuts, outlet elbow and gasket.



15. REMOVE TURBOCHARGER STAY


A099944E02
  1. Remove the 2 bolts, nut and stay.



16. REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY


A098817E02
  1. Remove the 2 bolts, 2 nuts, union bolt, inlet pipe and 3 gaskets.

    NOTICE:
    Do not loosen the nut labeled A.



17. REMOVE TURBOCHARGER SUB-ASSEMBLY


A098818E01
  1. Remove the 3 nuts, turbocharger and gasket.