Home › ENGINE ยท 2KD-FTV › INTAKE › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE MANIFOLD STAY
  1. Disconnect the 3 vacuum hoses from the 2 VSV.



    A148131
  1. Remove the 2 bolts and stay.



3. REMOVE OIL DIPSTICK GUIDE


A148132
  1. Remove the bolt and injection pipe clamp.

  1. Remove the bolt and guide.

  1. Remove the O-ring from the guide.



4. REMOVE EGR COOLER
  1. Remove the EGR cooler (Click here).



5. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY


    A152275
  1. Remove the bolt and disconnect the injection pipe clamp.

    NOTICE:
    If an injection pipe clamp is removed from the No. 4 injection pipe, replace the injection clamp with a new one.



    A152276E05
  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.



6. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY


    A152338E02
  1. Disconnect the 3 fuel hoses.

  1. Remove the check valve, 3 bolts, leakage pipe and gasket.



7. REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET


    A149935
  1. Remove the bolt and support bracket.



8. REMOVE INJECTION PIPE SUB-ASSEMBLY


A098967E06

NOTICE:
  1. After removing the fuel pipe, cover the outlets on the common rail with tape to keep out foreign matter.
  2. After removing the fuel pipe, put it in a plastic bag to prevent foreign matter from contaminating its injector inlet.

  1. Remove the 2 nuts and No. 3 injection pipe clamp.

  1. Remove the bolt and No. 2 injection pipe clamp.



  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.



      A098893E01
    1. Remove the 2 bolts and disconnect the 2 injection pipe clamps.



    2. A098968E06
    3. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.



9. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY


A098898E01
  1. Disconnect the 2 fuel hoses.

  1. Remove the check valve, 3 bolts, leakage pipe and gasket.



10. REMOVE INTAKE MANIFOLD INSULATOR


    A148158
  1. Remove the 2 bolts and insulator from the manifold.



11. REMOVE INTAKE MANIFOLD


A148133
  1. Disconnect the vacuum hose.

  1. Disconnect the VSV connector.

  1. Remove the 2 nuts, 4 bolts, intake manifold and gasket.