Home › ENGINE ยท 1KD-FTV › INTAKE › INTAKE MANIFOLD (w/ EGR Cooler)

INTAKE MANIFOLD (w/ EGR Cooler) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE MANIFOLD STAY
  1. Disconnect the 3 vacuum hoses from the 2 VSV.



    A148131
  1. Remove the 2 bolts and stay.



3. REMOVE OIL DIPSTICK GUIDE


A148132
  1. Remove the bolt and injection pipe clamp.

  1. Remove the bolt and guide.

  1. Remove the O-ring from the guide.



4. REMOVE EGR COOLER
  1. Remove the EGR cooler (Click here).



5. REMOVE NO. 3 INTERCOOLER SUPPORT BRACKET


    A149935
  1. Remove the bolt and support bracket.



6. REMOVE VACUUM CONTROL VALVE SET


    A149960
  1. Disconnect the 2 connectors and 3 vacuum hoses.

  1. Remove the 2 bolts and vacuum control valve set.



7. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY


    A152275
  1. Remove the bolt and disconnect the injection pipe clamp.



    A152276E02
  1. Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.



8. REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
  1. Disconnect the 3 fuel hoses.



    A152338
  1. Remove the check valve, 3 bolts, leakage pipe and gasket.



9. REMOVE INTAKE MANIFOLD INSULATOR


    A149964
  1. Remove the 2 bolts and insulator from the manifold.



10. REMOVE INTAKE MANIFOLD


    A149936
  1. Disconnect the common rail sub-harness connector from the intake manifold.



    A149965
  1. Remove the 2 nuts, 4 bolts, intake manifold and gasket.