Home › ENGINE ยท 2KD-FTV › INTAKE › TURBOCHARGER (w/o EGR Cooler)

TURBOCHARGER (w/o EGR Cooler) > INSPECTION

for Preparation Click here



1. VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY


    A230524E01
  1. Check for deformation and cracks in the turbine wheel on the exhaust side.
    If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
    Text in Illustration 
    *1
    Turbine Wheel



2. INSPECT AXIAL PLAY OF TURBINE SHAFT


    A110335E01
  1. Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft using a dial indicator.

    Maximum axial play:
    0.08 mm (0.0031 in.)

    NOTICE:
    Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.

    If the axial play is greater than the maximum, replace the turbocharger sub-assembly.



3. INSPECT RADIAL PLAY OF TURBINE SHAFT


    A110337
  1. Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.

  1. Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft.

    Maximum axial play:
    0.110 mm (0.0043 in.)

    If the radial play is greater than the maximum, replace the turbocharger sub-assembly.



4. CHECK TURBINE SHAFT ROTATION


    A110325
  1. Rotate the turbine wheel with your finger and check that it rotates smoothly.

    HINT:
    Even if it takes effort a little to rotate the turbine wheel, this is not a problem.

    If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.



5. INSPECT ACTUATOR AND WASTE GATE VALVE OPERATION


A099568
  1. Disconnect the actuator hose from the compressor housing.

  1. Using SST, apply pressure to the actuator.

    SST
    09992-00242  

    Valve opening pressure:
    Specified pressure* (See attached table below)

    NOTICE:
    Never apply more than predetermined maximum pressure* to the actuator.


    HINT:
    *: Valve opening pressure and predetermined maximum pressure above differ according to the turbocharger. For the specifications, see attached table below.

    Specifications: 
    Engine Type
    Turbocharger Sub-assembly
    (Part No.)
    Valve Opening Pressure
    (kPa: Gauge Pressure)
    Maximum Pressure
    (kPa: Gauge Pressure)
    Reference:
    Rod Stroke
    (mm)
    2KD-FTV
    17201-0L030
    17201-30120
    114
    136
    0.98 to 1.91
    17201-0L050
    123
    147.8
    0.89 to 1.74
    17201-30141
    135
    156.5
    0.72 to 1.39

  1. Check that the actuator push rod moves and that the waste gate valve opens.
    If the rod does not move, replace the turbocharger sub-assembly.

  1. Reconnect the actuator hose to the compressor housing.