TURBOCHARGER (w/ EGR Cooler) > INSPECTION |
| 1. VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY |
![]() |
For Waste Gate Type Turbocharger (vacuum controlled actuator):
Check for deformation and cracks in the turbine wheel on the exhaust side.
If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
|
*1 | Turbine Wheel |
![]() |
For Variable Nozzle Type Turbocharger (motor controlled actuator):
Check for deformation and cracks in the turbine wheel on the exhaust side.
If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.
|
*1 | Turbine Wheel |
| 2. INSPECT AXIAL PLAY OF TURBINE SHAFT |
For Waste Gate Type Turbocharger (vacuum controlled actuator):
![]() |
Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft using a dial indicator.
For Variable Nozzle Type Turbocharger (motor controlled actuator):
![]() |
Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.
Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft.
| 3. INSPECT RADIAL PLAY OF TURBINE SHAFT |
For Waste Gate Type Turbocharger (vacuum controlled actuator):
![]() |
Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.
Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft.
For Variable Nozzle Type Turbocharger (motor controlled actuator):
![]() |
Using a dial indicator, insert the needle of the dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.
Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft.
| 4. CHECK TURBINE SHAFT ROTATION |
For Waste Gate Type Turbocharger (vacuum controlled actuator):
![]() |
Rotate the turbine wheel with your finger and check that it rotates smoothly.
For Variable Nozzle Type Turbocharger (motor controlled actuator):
![]() |
Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.
| 5. INSPECT ACTUATOR AND WASTE GATE VALVE OPERATION (for Vacuum Controlled Actuator) |
![]() |
Disconnect the actuator hose from the compressor housing.
Using SST, apply pressure to the actuator.
| Engine Type | Turbocharger Sub-assembly (Part No.) | Valve Opening Pressure (kPa: Gauge Pressure) | Maximum Pressure (kPa: Gauge Pressure) | Reference: Rod Stroke (mm) |
| 2KD-FTV | 17201-0L030 17201-30120 | 114 | 136 | 0.98 to 1.91 |
| 17201-0L050 | 123 | 147.8 | 0.89 to 1.74 | |
| 17201-30141 | 135 | 156.5 | 0.72 to 1.39 |
Check that the actuator push rod moves and that the waste gate valve opens.
If the rod does not move, replace the turbocharger sub-assembly.
Reconnect the actuator hose to the compressor housing.