THERMOSTAT (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 4 bolts and cover.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
![]() |
Drain the coolant by removing the reservoir cap and, using a wrench, remove the vent plug.
Loosen the cylinder block drain cock plug.

| 4. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disconnect the MAF meter connector and remove the clamp.
Loosen the hose clamp of the compressor inlet elbow.
for Ventilation Hose Type:
Disconnect the ventilation hose.
Remove the 2 bolts and air cleaner.
| 5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts, 2 nuts and cover.
| 6. REMOVE INTERCOOLER ASSEMBLY WITH INTAKE AIR CONNECTOR |
![]() |
Detach the 2 clamps.
Disconnect the vacuum hose from the manifold absolute pressure sensor.
Disconnect the IAT sensor connector and manifold absolute diesel pressure sensor connector.
![]() |
Loosen the 2 clamps.
![]() |
Remove the 4 bolts and intercooler.
| 7. REMOVE COMPRESSOR INLET ELBOW |
![]() |
for Ventilation Pipe Type:
Remove the ventilation pipe.
Move the clamp so that the hose can be disconnected.
Remove the ventilation pipe.
Disconnect the 2 connectors from the turbocharger.
Remove the wire clamp's clip from the inlet elbow.
Remove the 2 nuts, inlet elbow and gasket.
| 8. DISCONNECT RADIATOR HOSE INLET |
| 9. DISCONNECT NO. 1 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP (for Automatic Transmission) |
![]() |
Remove the bolt and disconnect the clamp.
| 10. REMOVE WATER INLET |
![]() |
Remove the 3 bolts and water inlet.
| 11. REMOVE THERMOSTAT |