Home › ENGINE ยท 5L-E › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine and then wait for 5 minutes after turning the engine off. The oil level should be between the low level and full level marks of the dipstick.

    1. If low, check for leakage and add oil up to the full level mark.

      NOTICE:
      Do not add engine oil above the full level mark.



2. CHECK ENGINE OIL QUALITY


  1. Check the oil for deterioration, water contamination, discoloring, or thinning.
    If the quality is visibly poor, replace the oil.

    HINT:
    1. TOYOTA Genuine Motor Oil is in this vehicle when it is shipped.
    2. Use TOYOTA approved TOYOTA Genuine Motor Oil or equivalent to satisfy the following grade and viscosity.

    Oil grade:
    API grade CF-4 or CF (You may also use API CE or CD) SAE 5W-30 is the best choice for your vehicle, for good fuel economy, and good starting in cold weather.



    A112498E09



3. CHECK OIL PRESSURE
  1. Disconnect the oil pressure switch connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    A058649E01
  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard oil pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf*cm2, 4.3 psi) or more
    3,000 rpm
    294 to 539 kPa (3.0 to 5.5 kgf*cm2, 43 to 78 psi)

    If the oil pressure is not as specified, check the oil pump.

  1. Remove the oil pressure gauge.



4. INSTALL OIL PRESSURE SWITCH


    A113490E01
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.